SWG-0034, FP10, SIREN, 400V +/- 10% , 50Hz, 60 DEGREES, ATEX
- Brand:Klaxon
- Product Code:SWG-0034
- Availability:Please Call or Email Us to Check Availability
Klaxon, SWG-0034, FP10, SIREN, 400V +/- 10% , 50Hz, 60 DEGREES, ATEX (7.5Kw de-rated to 5.5Kw for 60°C operation, 11A)
The FP range of conventional motor powered sirens provides a basic solution to address wide area mass alert signalling in hazardous area locations for all industrial, civil, commercial and environmental requirements.
The products are of simple rugged construction and provide a low frequency traditional air raid sound
Features
- Audibility range between 135db @ 1 metre, (105db @ 30metres) for the smallest unit to 140db @ 1 metre, (110db @ 30metres for the largest unit. Sirens in this range in increasing order of sound output are the FP6 & FP10 units.
- 475Hz constant tone signal.
- ATEX approved for zone 1 & 2.
- Overall siren standard approval Exd IIG IIC T4.
- Non electrical parts standard approval EExc IIC T1..T6 X.
- Roughly omni-directional sound coverage which peaks in the direction of the front stator face.
- 400Vac +/- 10% 50Hz 3 phase nominal power supply requirement. (Alternative voltages and frequencies available on request).
- Operating temperature range for the FP6 & FP10 units of -20 to +60 degrees C.
- Cast aluminium & steel construction.
- Environmental rating of IP55.
- If the power supply to the sirens is pulsed to enable the siren to produce a ‘wail’ tone then the maximum run time of the siren is reduced from continuous for constant tone to 15 minutes or less.
- Control units can be supplied to enable the siren to produce the ‘wail’ tone signal with associated control switches. The controls are only suitable for locating in a non-hazardous area.
- The Motor windings are tropicalized as standard.
- Anti-condensation heaters for the motor can be supplied.
- The standard siren builds offered are fitted with EExde rated motors but EExd motors can be supplied.
For more details, please refer with our attached manual.
Contact us on sales@hunters-wholesalers.co.uk for more specific product information and pricing installation and training.